Tell us about the job
Takes about a minute. No obligation.
A contractor sizing a furnace in Pulaski County works from heat-loss calculations and the specifics of the house, because the weather record here does not describe a relentless operating load that would push a new system toward early limits. 69 severe weather events were recorded in Pulaski County, Illinois between 2015 and 2024. At that rate, severe weather is something equipment here encounters from time to time, not a steady condition it runs against every season. That means installation quality and proper sizing carry more weight in how a furnace performs over the years than any weather exposure a system in this county is likely to accumulate.
Ductwork laid down for an older furnace carries assumptions about airflow, trunk sizing, and return placement that a new unit may not share. Half the homes in Pulaski County, Illinois were built in 1969 or earlier (2020-2024 ACS 5-year). A contractor quoting a furnace installation here has to trace the existing duct runs and check whether the system as built will move enough air for the replacement equipment, because adapting what is there is a different job than swapping the box. Electrical service matters too, but the duct layout is what drives whether the scope changes on the day the crew arrives.
What Gets Installed With a New Furnace
The furnace itself sits in the basement, utility room, or closet and is the unit that produces heat. A burner assembly inside it burns fuel to generate that heat, and a heat exchanger transfers it to the air that moves through your home. The flue pipe runs from the furnace up and out of the house, carrying combustion gases away.
The blower motor and blower wheel sit inside the furnace cabinet and push conditioned air out into the supply side of your duct system. The air filter mounts at the return-air opening, right where air enters the unit. A thermostat goes on an interior wall and is the control point that tells the furnace when to fire and when to stop.
The drawing shows a general layout of these components, and a licensed contractor determines exactly what applies to your house and its existing setup.
Get matched in Pulaski CountyPulaski County, by the numbers
69 severe weather events were recorded in Pulaski County, Illinois between 2015 and 2024.
NOAA National Centers for Environmental Information, Storm Events Database, bulk CSV export, events 2015-01-01 through 2024-12-31.Half the homes in Pulaski County, Illinois were built in 1969 or earlier (2020-2024 ACS 5-year).
U.S. Census Bureau, 2020-2024 American Community Survey 5-Year EstimatesPulaski County, Illinois holds 2,851 housing units (2020-2024 ACS 5-year).
U.S. Census Bureau, 2020-2024 American Community Survey 5-Year EstimatesOwners occupy 68.2% of the occupied homes in Pulaski County, Illinois (2020-2024 ACS 5-year).
U.S. Census Bureau, 2020-2024 American Community Survey 5-Year EstimatesCodes & Standards Covering Furnace Installation in Pulaski County, Illinois5 sourced rules and standards
What happens once a contractor comes out
Non-weatherized gas furnaces manufactured on or after November 19, 2015 must reach 80.0 percent AFUE.
Non-weatherized oil-fired furnaces manufactured on or after November 19, 2015 must reach 83.0 percent AFUE.
Mobile home gas furnaces manufactured on or after November 19, 2015 must reach 80.0 percent AFUE.
Non-weatherized gas furnaces manufactured on or after December 18, 2028 must reach 95.0 percent AFUE, up from the 80.0 percent minimum that applies to units manufactured before that date.
Licensing Rules for HVAC Work in Pulaski County, Illinois
Illinois leaves HVAC licensing to the municipality: state law lets the corporate authorities of each city or village examine, license and regulate heating, air conditioning and refrigeration contractors, and caps the licence fee they may charge at $50 — so who licenses you depends on the town you work in.
Severe Weather Events in Pulaski County
Heating equipment in Pulaski County works against whatever the climate puts on it, and that workload shapes what a proper installation needs to handle. A furnace sized and fitted for local conditions lasts longer and performs more reliably than one spec'd to a national average.
69 severe weather events, 2015–2024. Source: NOAA National Centers for Environmental Information, Storm Events Database.